Duex5

The Duex5 has the following features:

• 5 additional TMC2660 stepper motor drivers with stall notification.
• 5 additional extruder heater outputs.
• 5 servo outputs with 5V power and 5V signal levels, sharing control channels with the heaters, so you can use unused heater channels to drive servos.
• 5 additional endstop inputs with indicator LEDs and 3.3V/5V voltage selection. These are also usable as outputs.
• 5 additional controlled fan outputs, also usable for driving LEDs etc. The output voltage may be switched between 5V, 12V and VIN.
• 4 uncommitted general purpose I/O pins.
• 12V switching regulator, for generating a 12V supply for fans, LEDs etc. when the VIN power is higher than 12V.
• 5 additional thermistor inputs.
• Support for 2 more thermocouple or PT100 daughter boards, supporting up to 4 more sensors.
• Optional 5V external power input for powering servos, fans etc.
• 
  
• For more information see the Wiki.
• 
  
• Documentation and Support.

  The documentation is available on the Duet3d Wiki. Users are strongly urged to refer to the documentation for help with commissioning and configuring their Duet Wifi boards. We will continue to review and extend the documentation based on user feedback, please use the Duet3d forum as the first point of contact for support.

  Further Developments.

  We are working on further firmware development and hardware add-ons. We encourage user feedback to help shape the priority of work for firmware and hardware add-ons through discussion on the forum (see thefirmware wishlist for example).

  Duet3d always supply our boards with connector packs as standard at no extra cost :-)
  

"UK customers should buy from duet3d.com".